Pneumatech HTM02-01, Operation And Maintenance Manual

Page: 43 / 93

Installation, Operation and Maintenance Manual
Medical Vacuum Plant Page 55
Table 8-11; Central controller – ECO slave settings
Parameter Function Min.
setting Factory
setting Max.
setting Unit
Scheme X
priority To put this pump in a certain priority queue,
based on the scheme selected (see master
parameter “Scheme In Use” ) 1 1 6 -
Start/load
reaction time To program the time interval in which the
start command from the central controller
should result in the pump running 1 40 300 sec
Stop reaction
time To program the time interval in which the
stop command from the central controller
should result in the pump stopping 1 60 300 sec
Running hours To adjust running hours for pump X to
influence the even wear control algorithm 0 X 500000 hrs
Mode See below - Integrated - -
Manual
sequence group Only when Manual sequence is active.
Defines to which manual sequence group
this slave belongs. 1 1 6 -
Starting
To start the system, after having completed the CAN and ECO setup described above, carry out
the following steps:
1. Turn the pumps’ main switch to On and the Local/LAN switch to LAN. The Emergency
Forced Local warning (see Interface icons and menu structure) and red LED is present on
the display since the pressure is above -590 mbar(e). Once the pressure is below -590
mbar (on the display of the pump controller), the Escape button must be pressed on the
pump controller (see Interface icons and menu structure) which will make the warning to
disappear and the red LED to go out.
2. Start the ECO system (full access mode, see above).