Pneumatech HTM02-01, Operation And Maintenance Manual

Page: 31 / 93

Installation, Operation and Maintenance Manual
Medical Vacuum Plant Page 55
Figure 8-7; Example of running hours on display since last service
The number of running hours since the last service is shown. Press Enter (enter your password if
it is set) and press Enter again to confirm. The service interval defined in <P. 5> will be
subtracted, the blue LED will go out and the service warning will disappear.
CAN settings
Submenu <P. 2> can be used to change the CAN address and to turn CAN Off or On.
Normally these settings are set correctly during production and should not be changed. The CAN
address is unique per pump and defines the cut-in and delay value in Local mode. The CAN
address should correspond to the figure indicated on the label on the pump cubicle.
CAN should be put to Off prior to change the CAN address. Do not forget to put CAN to On after
the CAN address has been set.
Figure 8-8; Pump controller – CAN settings
IP settings
When scrolling down further to submenu <P. 3>, the IP submenu is accessible. When the user
wants to connect to this controller directly through LAN/IP, the settings can be modified according
to the following diagram.