TECHNICAL SUPPORT: [email protected] | (760) 727-0300
PG. 25
THIS DOCUMENT IS PROPRIETARY AND CONFIDENTIAL. © 2021 PRECISION MEASUREMENT ENGINEERING, INC. ALL RIGHTS RESERVED.
CAUTION: Environments where debris can get trapped inside the sensing area should be avoided when using this
product. PME recommends using the Cu plate in such environments.
H O W T O I N S T A L L T H E C U P L A T E O N A M I N I DO T C L E A R L O G G E R :
1. Use a Phillips
screwdriver to remove
3 of the 6 screws
(every other one). Do
NOT remove all
screws. At least 3 must
always remain
screwed in.
2. Position the Copper
Plate faced down so
that the notches in the
Copper Plate perfectly
align over sensing foil
and over the screw
holes.
3. Install the three pan
head screws included
in the kit. Gently
tighten.
Save the ss316 screws. They will
be needed if the Cu mesh is
removed.
3.6 Final Mounting Instructions
Appropriate mounting of miniDOT Clear at the deployment site is the customer's responsibility. PME
provides the suggestions below.
