TECHNICAL SUPPORT: [email protected] | (760) 727-0300
PG. 24
THIS DOCUMENT IS PROPRIETARY AND CONFIDENTIAL. © 2021 PRECISION MEASUREMENT ENGINEERING, INC. ALL RIGHTS RESERVED.
Caution: Improper replacement of the batteries will damage the miniDOT Clear Logger.
Follow these steps:
1.
Move the miniDOT Clear Logger’s Control Switch to the “Halt” position.
2. Remove the depleted batteries noting the position of the (+) terminal.
3. Use only new, fully charged batteries, both of the same type.
4. Install fresh batteries with the (+) position the same as the removed batteries. The (+)
position is also marked on the inside of the battery holder.
5.
The miniDOT Clear Logger’s LED Light should flash to indicate that the software is beginning
operation within a second or two after you complete the battery installation. At this time, the
logger will enter the mode selected by the Logger Control Switch (which should initially be
“Halt” from Step 1).
Please be aware that the warranty will become void if the batteries are installed backwards.
3.5 Installing Copper Mesh or Plate
miniDOT Anti-Fouling Copper Kit includes:
•
1 Cu Wire Mesh Disc 1 Cu Plate
•
1 Nylon Ring
•
3 Phillips Pan Head Screws
H O W T O I N S T A L L T H E C U M E S H O N A M I N I D OT C L E A R L O G G E R :
1. Use a Phillips
screwdriver to remove
3 of the 6 screws
(every other one). Do
NOT remove all
screws. At least 3 must
always remain
screwed in.
2. Position the nylon ring
under the Cu mesh so
that the notches in the
nylon ring and Cu
mesh align over the
screw holes.
3. Install the three pan
head screws included
in the kit. Gently
tighten.
