000115682/151018/0 WallPro
EN - 8
• Determine on which side
14
you want to install the extraction
arm (left or right).
• Install the reinforcement plate on that side of the filter unit
with the 7 flange bolts M6x16.
Fig. 4.3 Mounting of the reinforcement plate
4.3.2 Inlet non-return valve (assembly)
Applies to all types of units
You must install the assembly, that consists of an inlet flange
with non-return valve, on the side panel of the filter unit. In
case of a WallPro Double, you must install an assembly on
both side panels.
The side panels are universal, so you can install
them either left or right.
To install the assembly, do the following.
• Depending on the mounting position
15
, determine the
inside of the side panel.
• Put sealing material (E) around the inlet opening on the
inside of the side panel.
• Insert the assembly from the inside of the panel through
the opening. Make sure that the axis of the non-return
valve is in vertical position (B).
• Attach the assembly (A) to the side panel with the 6 bolts
M6, washers and nuts.
• Secure the non-return valve to the inlet flange with 2
self-tapping screws (F+G). Two small holes in the inlet
flange indicate the correct position. Make sure that you
install one screw on top and the other one at the bottom of
the assembly.
• Make sure that the non-return valve can fully open.
In case of a LL-5.5/24 | Manual on/off switch on the
hood, incl. LED working light (option)
• Install the cable gland M16 + nut M16 (C).
If not:
• Install the screw plug M16 + nut M16 (D).
14. In case of a WallPro Double you must install a reinforcement plate on both
sides
15. On the left or right side of the filter unit
A
B
E
F
G
C
D
A
B
E
F
G
C
D
Fig. 4.4 Inlet non-return valve (assembly)
4.3.3 Side panel
In case of:
DM
Make sure that you have the 4 bolts M12 at hand
that you need to install the arm bracket.
For the correct use of SealApplicator, refer to the
instruction sheet that is supplied with the spray
bottle.
Refer to Fig. V on page 23 for the exact mounting
position of the side panel with respect to the cover
plates (top + bottom) .
• (1) Remove the backing material of the seals.
• (2) Spray SealApplicator lubricant on the seals
16
.
• (3) Put the side panel
within 60 seconds
17
on the filter
unit.
• (4) Align the side panel with the 4 bolts M12x30 into the
cage nuts and partly tighten them
18
.
• (5) Install the side panel with the 24 bolts M6x16 + sealing
washers M6.
• (6) Disassemble the 4 bolts M12x30.
16. By the use of SealApplicator you can slightly shift the side panel to get the
right position. After approx. 60 seconds the lubricant is dry so you cannot shift
anymore.
17. After approx. 60 seconds SealApplicator lubricant loses its functions and you
cannot shift anymore.
18. You must remove them later on to install the arm bracket.
