Plymovent WALLPRO, Installation And User Manual

Page: 15 / 29

000115682/151018/0 WallPro EN - 14
Fig. 4.22
mba
r
6
1
0
15
20
25 30 3
5
4
0
4
5
50
Differential pressure switch
4.10 Fan outlet
The fan has a rectangular outlet with grid for recirculation
30
of
the filtered air into the workshop. In that case the supplied fan
outlet transition –from rectangular to round– is redundant.
For mounting to the optional silencer
31
or an outlet duct, you
must install the fan outlet transition first. The table below
shows the various outlet possibilities.
Fan outlet
Recirculation
Outlet
transition
Outlet duct Exhaust to atmosphere
Silencer Recirculation
Outlet duct Exhaust to
atmosphere
4.10.1 Fan outlet transition
Fig. 4.23
• Determine the desired outlet configuration.
In case of direct recirculation of the air, the outlet transition is
redundant.
If applicable:
• Disassemble the grid (A).
• Install the outlet transition (B) to the fan with the bolts and
nuts of the grid.
• Install the the optional silencer and/or the outlet duct to
the outlet transition.
30. Make sure that recirculation is allowed by state or local regulations
31. Refer to paragraph 1.3
Fig. 4.23
A
B
Fan outlet transition
4.11 Commissioning checklist
# Check Ref.
par.
OK
1.
Are all cables correctly installed?
4.9.1
2.
Are the air hoses (+ and –) correctly
installed?
4.9.1
3. Is the direction of rotation of the fan
correct? An arrow on the fan housing
indicates the correct direction.
4. Is the filter unit connected to the
compressed air supply?
4.5
5. In case of the optional LL-5.5/24 (on/off
working light):
Are all cable glands fully tightened?
4.7.1
6.
Is the pressure setting correct?
4.9.2
7.
Is the shut-off valve of the dustbin
open?
4.8
5 USE
WARNING!
Fire hazard! Do not use the product for polishing
applications in combination with grinding, welding or
any other application that generate sparks.
Refer to chapter 3 / Safety instructions / Use.
5.1 Control panel
The WallPro has a separate control box. Controls and
indicators:
Fig. 5.1
A POWER ON | white LED that indicates that the control box
is connected to the mains and that the power is on
B FILTER CLOGGED | red LED that indicates that it is
necessary to replace the filter cartridge
C Main switch | to (de-)energize the entire unit
D FILTER CLEANING | blue push button with LED to activate
the filter cleaning system manually
E START/STOP FAN | green push button with LED to start and
stop the fan