Plustek V1.2, User Manual

Page: 12 / 44

4
of the scanner marked HOST (see Figure 1 and step 1).
5. Connect the male end of the SCANNER CABLE into the
PC’s printer port (see Figure 1, and step 1).
Attention: If you do not have a printer connected to your
computer and are not sure where the printer port is
located, see your computer’s information book and read
the section about the printer port connector .
6. Next, plug the disconnected printer cable into the rear of the
scanner marked PRINTER (see Figure 1 and step 2).
7. After plugging the scanner and printer cables into their
respective locations, plug the power adapter into the
scanner’s power receptor (see Figure 1 and Step 3).
8. Plug the power adapter into a standard AC outlet or wall
branch.
Only use the power adapter that is included with your
scanner. The use of a different power adapter may
damage the unit and void your warranty !
9. Plug in all power cords and turn on your computer.
10. Install the scanner’s software (see Chapter II. Software Setup
page 5).
Attention
Danger