Chapter I. Setup the eDoc Manager
Before you setup the eDoc Manager, please make sure all components are available
and ready.
A list of the package contents is provided in the
section of
this guide. If any items are damaged or missing, please contact the vendor where you
purchased your eDoc Manager or our customer service directly. This chapter will
guide you through the physical installation of the eDoc Manager in your network.
Attention
Please make sure a hard disk is installed in the eDoc Manager
before you use the eDoc Manager.
Installing Hard Disk Drive
If there is no hard disk installed on the eDoc Manager, please install it before you
power on the eDoc Manager. The eDoc Manager supports SATA interface, 3.5-inch
hard disk, and you can choose to install one or two hard disks.
Before you install the hard disk drive, please backup the data stored in the hard disk
drive if there is any. After the installation is completed, the eDoc Manager will
automatically format the hard disk drive. It takes time to format the hard disk drive.
Follow the steps below to install the hard disk drive:
1. Use a screwdriver to open the cover located on the side of the eDoc Manager.
2. Connect the SATA adaptor and the power source.
3. Tighten the screws firmly on the side of the hard disk drive to secure the hard disk
drive.
4. Close the lid. Tighten the screws to secure the cover.
Setting up the eDoc Manager in your network
Follow the steps below to set up the eDoc Manager in your LAN environment:
6