TR-4-2
28 May 2009
TR-001
Fault Code TR-001, indicates that the Transport motor (TR-M1) does not receive any displacement
pulses.
Initial Actions
Check fuse F2 on Transformer.
Make sure that the Transport belt sensor (TR-Q4) is installed correctly (
TR 3.2.5).
Procedure
Enter the Service mode and select Transport motor (TR-M1) in check motors.
Does the encoder run properly, Parts catalog
page 13, Item 17?
Y
N
1. Check transmission (
3.2.17).
2. Replace motor TR-M1.
1. Replace sensor TR-Q4.
2. Disconnect plug B.P14 from PCB “A”. Measure between J14-13 and J14-15? (5V and ground).
The voltage is
approximately 5 VDC?
Y
N
Replace PCB “A”.
Disconnect plug from sensor TR-Q4. Check wires for Continuity / Short circuit from the white wire Q4 to B.P14-14.
Is there
Continuity and no Short circuit?
Y
N
Replace Wire Harness
Connect plug B.P14 to PCB “A”. Measure between the red wire Q4 and the black wire Q4 (5V and ground).
The voltage is
approximately 5 VDC?
Y
N
Replace wire Harness.
Replace PCB “A”.
FAULT CODE DESCRIPTIONS
Summary of Contents for TR5010e
