Plockmatic SQF-200 SquareFolder, Service Manual

Page: 59 / 85

SQF-4-10
12 February 2007 FAULT CODE DESCRIPTION
SQF-203
Fault code SQF-203, indicates that during Run the Clamp sensor (SQF-Q6), was not blocked
within timeout.
Initial Actions
Make sure that the sensor is clean.
Make sure that the Clamp sensor (SQF-Q6), is installed correctly.
Check fuse F3 on the Squarefolder Transformer.
Procedure
Enter the Service mode and select Clamp sensor (SQF-Q6) in check sensors. Block, then unblock, the Q6 sensor with a
sheet of paper.
The Clamp sensor (SQF-Q6) sensor indicates :0 when the sensor is blocked, and :1 when the sensor
is not blocked?
Y
N
Go to SQF-014 fault code.
1. Make sure that nothing interferes with the paper path.
2. Make sure that the Feeding belts are moving as they should.
3. Clean the Feeding belts.
SQF-202
Fault code SQF-202, indicates that at ”initialization” or during Run the Infeed sensor (SQF-Q5),
was blocked exceeding timeout.
Initial Actions
Make sure that the sensor is clean.
Make sure that the Infeed sensor (SQF-Q5), is installed correctly.
Check fuse F3 on the Squarefolder Transformer.
Procedure
Enter the Service mode and select Infeed sensor (SQF-Q5) in check sensors. Block, then unblock, the Q5 sensor with a
sheet of paper.
The Infeed sensor (SQF-Q5) sensor indicates :0 when the sensor is blocked, and :1 when the sensor
is not blocked?
Y
N
Go to SQF-013 fault code.
1. Make sure that nothing interferes with the paper path.
2. Make sure that the Feeding belts are moving as they should.
3. Clean the Feeding belts.
SQF-201
Fault code SQF-201, indicates that during Run (Operation) the Infeed sensor (SQF-Q5), was not
blocked within timeout after the exit signal from the Trimmer, was detected.
Initial Actions
Make sure that the sensor is clean.
Make sure that the Infeed sensor (SQF-Q5), is installed correctly.
Check fuse F3 on the Squarefolder Transformer.
Procedure
Enter the Service mode and select Infeed sensor (SQF-Q5) in check sensors. Block, then unblock, the Q5 sensor with a
sheet of paper.
The Infeed sensor (SQF-Q5) sensor indicates :0 when the sensor is blocked, and :1 when the sensor
is not blocked?
Y
N
Go to SQF-013 fault code.
Make sure that nothing interferes with the paper coming out from the Trimmer, and going into the Squarefolder.