Plockmatic MPS XL, Operating Instruction

Page: 29 / 44

29
3
Setting Long Sheet Guide & Long Sheet End Stop (continued)
7. Replace Paper Support (Section 1 - Setting the Paper Support).
8. Press Pause/Resume to make sure table is set at proper position to receive paper.
9. Place paper on Stacker Table and adjust Long Sheet End Stop to correct length
+3mm to 5mm (+0.12’’ to 0.20’’) and Long Sheet Guide to correct width +3mm to
5mm (+0.12’’ to 0.20’’) on each side.
*Recommendation: Start with all guides set loosely around the paper and then
tighten as the job has began to run. Guides set too narrow will result in jams.
Long Sheet Guide Long Sheet Guide
Long Sheet End Stop
10. Tighten Table Extension Locking Knob.
11. Remove paper used for setup.