Plockmatic MPS XL, Operating Instruction

Page: 24 / 44

24
3
Setting Sheet Guide & End Stop (continued)
Sheet Guide Width Knobs
Continued on next page...
End Stop Adjustment Knobs
5. Press the Pause/Resume button to set the Stacker table to its starting position.
6. Loosen Sheet Guide Width Knobs (2x) so Sheet Guide’s width can be adjusted.
7. Make sure End Stop Adjustment Knobs (2x) (one on each side) are loose to be able
to move the Sheet Guide Support.
8. Place paper on Stacker Table and adjust End Stop to correct 3mm to 5mm
(+0.12" to 0.20")
*Recommendation: Start with all guides set loosely around the paper and then
tighten as the job has began to run Guides set too narrow will result in jams.