Plockmatic MPS XL, Operating Instruction

Page: 34 / 44

34
5
Fault codes list
Fault
Code
Colour How to clear
1 Red
(Hard-Stop)
Use the Table Positioning Lever to lower the Stacker Table then
press Pause/Resume Button to reset.
2 Red
(Hard-Stop)
Check Infeed Unit Bottom Cover is clear from items on top of
Stacker Table and then press Pause/Resume Button.
3 Yellow
(Soft-Stop)
Remove paper stack then press Pause/Resume Button.
4 Red
(Hard-Stop)
Remove paper stack then power off / power on the Stacker.
5 Yellow
(Soft-Stop)
Remove paper stack then press Pause/Resume Button.
10 Red
(Hard-Stop)
Clear & clean sensor Infeed Sensor (Section 6 - Maintaining Your
Stacker) then press Pause/Resume Button.
11 Red
(Hard-Stop)
Clear & clean sensor Infeed Sensor (Section 6 - Maintaining Your
Stacker) then press Pause/Resume Button.
12 Red
(Hard-Stop)
Clear any jams in the Infeed Unit then power off / power on the
Stacker.
14 Yellow
(Soft-Stop)
Clear & clean sensor Stack Sensor (Section 6 - Maintaining Your
Stacker) then press Pause/Resume Button.
15 Yellow
(Soft-Stop)
Check for and remove any obstructions on Stacker Table, then
check for and remove any obstructions blocking Infeed Side
Guides then press Pause/Resume Button.
16 Red
(Hard-Stop)
Check for and remove any obstructions on Stacker Table, then
check for and remove any obstructions blocking Infeed Side
Guides then power off / power on the Stacker.
18 Yellow
(Soft-Stop)
Press Pause/Resume Button
19 Red
(Hard-Stop)
Clear & clean sensor Stack Sensor (Section 6 - Maintaining Your
Stacker) then power off / power on the Stacker.
25 Red
(Hard-Stop)
Ensure the Stacker is properly docked then press Pause/Resume
Button . Make sure job is submitted with the DFA Profile set to MPS
XL.
30 Red
(Hard-Stop)
Clear any obstructions under the Infeed Unit and then press
Pause/Resume button.
NOTE:
If the following steps do not rectify the problem an authorized technician will be required.
For any other fault, Power off / Power on the Stacker.