PlayNation Play Systems 1500DT, Manual

Page: 99 / 145

STEP 36C: TIRE SWING
IMPORTANT
: NOTE THE TIRE SWING LEGS ARE DESIGNED TO ACCOMODATE SWING BEAMS ON
UNEVEN GROUND (DOWN SLOPE). THEY ARE LONGER THAN REQUIRED. IF YOUR GROUND IS
RELATIVELY LEVEL, YOU MAY NEED TO EITHER A) DIG IN BOTH LEGS WHERE THEY MEET THE
GROUND, OR B) BEND THE LEGS OUT SLIGHTLY TO MATCH YOUR GRADE. (ALSO SEE STEP 48)
AN EXTRA PERSON IS NEEDED FOR THIS STEP
1: SIT THE SWING BEAM LEGS UPRIGHT.
2: TAKE THE ASSEMBLED TIRE SWING BEAM AND LEGS AND INSERT THE SWING BEAM INTO THE GAP BETWEEN THE
BACK RIGHT CORNER POST AND THE PANEL SLAT. PLACE A SMALL LEVEL ON TOP OF THE BEAM IN ORDER TO LEVEL
CORRECTLY.
3: WITH A 3/8" DRILL BIT, USE THE PRE-DRILLED HOLES IN THE END OF THE TIRE SWING BEAM AS A TEMPLATE FOR THE
HOLES THAT WILL BE DRILLED INTO THE CORNER POST.
TIRE SWING BEAM
BACK RIGHT
CORNER POST
RAMP
89