www.playcraftsystems.com
For Customer Service Call
800.333.8519 (U.S.A.) or 541.955.9199 (International)
SPIN MAX TOWER
INSTALLATION INSTRUCTIONS
Rev G
2/18/2021
PC-2476
Page 9 of 9
SPIN MAX BASE:
Shall be constructed of UV-stabilized, rotationally
molded, linear, low density polyethylene with an
average wall thickness of .250".
SPIN MAX BEARING HOUSE:
Shall be machined using 5" O.D. 1/2" wall with
welded 3/8" thick steel mounting plate and will
have a multi-stage baked-on powder coat finish.
SPIN MAX POST SUPPORT:
Shall be fabricated using 5" O.D. 7 gauge steel
post with welded 3/8" thick steel plate and will
have a multi-stage baked-on powder coat finish.
SPIN MAX SUPPORT
RING:
Shall be fabricated using 2" square 11 gauge steel
outer ring with welded 3/8" thick steel splice bars
and will have a multi-stage baked-on powder coat
finish.
SPIN MAX TOWER POST:
Shall be fabricated using 5" O.D. 7 gauge steel
tubing with welded 3/8" thick steel top plate, 1/4"
thick steel bottom plate and machined steel
spindle and will have a multi-stage baked-on
powder coat finish.
SPEED LIMITER ARM:
Shall be fabricated using 1-1/4" square 16 gauge
steel tubing with welded 3/8" thick steel plug and
3/16" thick steel clevis and will have a multi-stage
baked-on powder coat finish.
SPEED LIMITER BASE:
Shall be fabricated using 1/4" thick steel plate with
welded 3/16" thick steel tabs and 3/8" thick steel
ring blocks and will have a multi-stage baked-on
powder coat finish.
ROPE CLEVIS:
Shall be formed using 3/16" thick stainless steel
and will have a multi-stage baked-on powder coat
finish.
SPIN MAX TOWER NET:
Shall be made from 16mm steel-reinforced rope
with high-strength copolymer plastic intersection
connectors and machined aluminum end ferrules.
SPIN MAX BASE SPACERS &
ROTO FERRULE PLUGS:
Shall be machined from high strength aluminum.
SPIN MAX COVER PANEL HALVES,
TOP COVERS & TOP PLATE TRIM:
Shall be made from high density 3/4" sheet plastic
specially formulated for optimum UV stability and
color retention.
Specifications
POST CAP R5 DOME:
Shall be precision die-cast from a high-strength
aluminum alloy and will have a multi-stage baked-
on powder coat finish.
HARDWARE:
Shall be stainless steel, zinc/nickel plated or
galvanized as required to resist rust and corrosion.
Specifications
Periodically tighten all screws, bolts and nuts. A
periodic inspection of all parts is necessary. If a part
is broken or worn, replace immediately. For general
maintenance please refer to our Playground
Maintenance Manual.
Maintenance
