Playcore ultraPLAY uPLAY TODAY MADDIE'S CHASE UPLAY-006-N, Assembly Instructions Manual

Page: 33 / 86

Parts List
PART NUMBER QTY DESCRIPTION
02-07-0003 1 SQUARE DECK
33-12-0019 1
33-11-0004* 4 M10 x 30mm (1 3/16") BHCS BOLT
33-11-0200* 4 M10 FLATWASHER
33-11-0400* 4 M10 LOCK NUT
HARDWARE COMPLETE
Issued/Revised:
SQUARE DECK 02-07-5001
u
PLAY TODAY
800.458.5872
www.ultraplay.com
30
4/30/2013
Items listed below Hardware Complete line are included with Hardware Complete Number
Warning: During Installation, Hardware And Small Parts Are Choking Hazards For Young Children. Store
Unused Parts Appropriately Until Assembly Is Completed. Once Assembly Is Completed, Remove Any
Unused Parts From The Play Environment And Dispose/Save Them In A Secure Location. Any bolt end
protruding more than two full threads beyond the face of the nut causes risk of clothing entanglement.
Promptly cut-off flush, file smooth, and treat to prevent corrosion.
Unless Otherwise Specified, All Units of Measure are Each
Note: Peen Tee-Nuts and Flatwashers to match radius of pipe after assembly is complete.
Note: Loctite (supplied by others) should be used on any non-patch hardware.
INSTALLATION INSTRUCTIONS:
IMPORTANT: DETERMINE WHICH MOUNTING OPTION YOU ARE USING; SURFACE MOUNT, ONGROUND, OR IN-GROUND.
1. Trim out slots with utility knife if necessary.
2. Place Uprights into position with clamp flange pointing inwards.
NOTE: POST MUST BE SUPPORTED UNTIL ALL HARDWARE IS INSTALLED.
3. Attach Deck to Uprights using M10 x 30mm B.H.C.S. Bolt, M10 Flat Washer, and M10 Lock Nut. See Detail 044.
4. Level Deck and make the appropriate adjustments.
5. Plumb and level entire assembly before tightening all fasteners. NOTE: Apply Loctite to threads of Bolt to prevent from loosening.
MAINTENANCE PROCEDURE:
Periodically check hardware for tightness, and tighten as necessary. Always check all parts for breakage or wear, and immediately
put equipment out of service until any faulty parts found are repaired or replaced. Also Check all metal parts for rust, paint loss and
touch-up if necessary with paint. Check for welded areas and verify integrity. Check periodically resilient surfacing for appropriate
depth and remove extraneous materials that could cause injury, infection, or disease. Maintain detailed installation, inspection,
maintenance, and repair records for each public-use playground equipment.