Plas-Ties XL2, Operating Manual, Page: 15 / 42

P
EDESTAL
S
TAND
A
SSEMBLY
Page 15
SECTION III Operation
1) Lay out all the parts on the floor. Place legs (A&B) with the wheels, parallel to each other as shown
2) Attach the upright (C) to the legs (A&B) using 4 bolts (505D031) and 4 washers (56806)
3) Attach cross bar (D) to the legs using 4 bolts (56426) and 4 washers (56806) to the front of the legs
4) Place the adjustment upright (E) inside the stationary upright (C). The adjustment upright is held in place by
the non-locking spring plunger and secured by the lever clamp.
5) Place the support plate tube (F) inside the tube on the adjustment upright and secure the lever clamp
6) Add the pedestal stand bracket (505D028) to (F) using 4 screws (P001952 ) and 4 washers (P004715 )
7) Screw 4 washers (16614) and 4 Hex Nuts (56507) to secure the bracket to (F)
8) Attach XL2 machine frame (505D173) to top of bracket (505D028) with 4 washers (P004715) and 4 screws
(P002201). Under the bracket attach with 4 washers (P004715) and 4 nuts (56507).
9) Mount the pedestal stand bracket (505D028) with attached XL2 to support plate (F).