Plas-Ties XL2, Operating Manual, Page: 14 / 42

Figure 3
Page 14
SECTION III Operation
M
OUNTING
STANDARD MOUNT
*
Standard equipment. Use with large or small brake
1) Remove the Brake Assembly from packaging and install on the brake
arm support using the two 1/4-20 x 1/2 screws provided.
2)
Follow Loading Twist Tie Material Instructions. (see page 18)
SIDE MOUNT
*Optional Part #56108. Use with large brake only
1) If currently set up for horizontal operation, remove brake assembly by
removing the two screws.
2) Mount brake assembly on mounting plate with the same screws
3) Lay machine on left side so that it is supported by the mounting stand
4) Bolt the side mount stand to the XL2 external chassis bracket.
5) Follow Loading Twist Tie Material Instructions. (see page 18)
PEDESTAL STAND
(for either horizontal or vertical mount)
*
Optional part # 505R033-XL, plus use special brake
#A102020.
1) Remove cover
2) Pull apart the 6 Molex connectors on harness
3) Remove legs from bottom of chassis & install pedestal mount.
4) Re-install, tighten, re-connect steps 1 and 2.
** Please note that the Brake Beam positioning as illustrated in Fig 3 has
the Roller Assembly pointed down when installed on the Pedestal Mount.