![background image](http://html1.mh-extra.com/html/plantronics/habitat-soundscaping/habitat-soundscaping_installation-manual_1565733006.webp)
6
Enclosed Waterfall
CAUTION: WHEN SERVICING YOUR WATER FEATURE MAKE SURE THAT YOU DISCONNECT ALL ELECTRICAL AND LIGHTING.
Midwest Tropical Inc • 3420 West Touhy Ave • Skokie, IL 60076 USA • Phone: (847)679-6666 • Fax: (847)679-6669
Install bulb in UV
Position the
waterfall
Use a platform dolly under each end of the waterfall to move the
waterfall into position easily. Take the waterfall off the dollies and
slide into its final position.
If the waterfall is not level, use shims to level the waterfall.
1. Placing the level on the waterfall base lid, slightly tilt the waterfall
and insert the thinnest end of a shim between the floor and the
bottom of the waterfall unit. Check the level again. Use a mallet to
tap the shim further into the underside of the base, if necessary.
Repeat the process until the base is level on all sides.
2. Once the base is level, break off or cut the exposed ends of the
shims.
3. Place the header on top of the water fall.
NOTE Because the header is heavy, it is best to use two people to
move and position it.
Using the suction cup glass holders, remove the base lids. Remove
all packaging inside the base. The waterfall ships with the plumbing
installed except the UV bulb and bulb sleeve to prevent damage
during transit.
1. To install the bulb and sleeve, unscrew the ballast from the lamp
housing.
Installation
Level the
waterfall
Ballast