![background image](http://html1.mh-extra.com/html/plantronics/habitat-soundscaping/habitat-soundscaping_installation-manual_1565733007.webp)
7
Enclosed Waterfall
CAUTION: WHEN SERVICING YOUR WATER FEATURE MAKE SURE THAT YOU DISCONNECT ALL ELECTRICAL AND LIGHTING.
Midwest Tropical Inc • 3420 West Touhy Ave • Skokie, IL 60076 USA • Phone: (847)679-6666 • Fax: (847)679-6669
Installation
2. Wearing gloves or holding the bulb with a cloth (avoid touching
the bulb; oils from your skin will reduce the bulb lifespan), align
the center groove on the bulb with the pin on the inside of the
ballast.
3. Push the bulb in firmly.
4. Slide the bulb sleeve over the bulb until the rubber ring touches
the ballast housing.
5. Slide the bulb into the lamp housing. Screw the ballast back into
the lamp housing until it is hand tight.
Do not overtighten!
6. Screw the lamp housing back into the base plumbing.
7. Do a quick check to make sure the UV light powers on. Look for
the three translucent rings to light up. Do not leave the light on
for more than 10 seconds. If it doesn’t illuminate, unscrew the
ballast and check to make sure the sleeve and bulb are correctly in
place.
Chase or run the cables for the water pump, UV sterilizer, and
lighting fixture (if purchased) out of the small hole on the side/back
of the waterfall base. Ensure the cords reach the outlet. If the cords
don’t reach, use a power strip and an extension cord.
CAUTION Do not plug in any components until you’ve filled the
panel with water.
Chase cables to
power