![background image](http://html1.mh-extra.com/html/plantronics/habitat-soundscaping/habitat-soundscaping_installation-manual_1565733018.webp)
18
Enclosed Waterfall
CAUTION: WHEN SERVICING YOUR WATER FEATURE MAKE SURE THAT YOU DISCONNECT ALL ELECTRICAL AND LIGHTING.
Midwest Tropical Inc • 3420 West Touhy Ave • Skokie, IL 60076 USA • Phone: (847)679-6666 • Fax: (847)679-6669
Component replacement
Pump
(replace as
needed)
Because you are using distilled water inside of an enclosed waterfall,
your waterfall pump requires little maintenance; however should
your pump fall outside of warranty, you will need to replace it.
To replace the pump:
You will need: towels, bucket, plumbers tape
1. Disconnect power to the waterfall.
2. Remove front base lid.
3. Turn the primary control and water pump valves to the OFF
position (perpendicular to pipe). This will prevent water from
draining from the waterfall while servicing. However water will
be inside the pump, so have towels on hand.
4. Remove the quick disconnects at the inlet and outlet of the
waterfall pump.
5. Carefully remove pump from base and discard the leftover water
into a bucket or drain.
6. Remove the plumbing connections and transfer them to the
replacement pump.
7. Use plumbers tape on the threads of the new pump before
transferring the piping to the new pump.
8. Ensure the piping is tightly threaded onto the new pump before
reconnecting to the quick disconnects.
9. Turn the water supply and water pump valves to the ON position
(parallel to pipe).
10. Check for leaks around the pump. Tighten fittings.
11. Connect power to the waterfall and test.