- 6 -
Chapter 2: Hardware Installation & Setup
This chapter provides information about your BLW-04G’s
physical features
and gives step-by-step installation instructions.
2-1 Rear Panel & Connections
The following figure shows the rear view of the BLW-04G and illustrates how
the cables connect to the interfaces on the rear panel.
y
Plug one end of the UTP cable into the
WAN port, the other into the RJ45
Ethernet jack on your ADSL or Cable
modem.
y
Connect a PC, which must have an
Ethernet NIC (Network Interface Card)
installed, to one of the LAN Ports.
y
Connect the external power supply to
the BLW-04G.
y
The Reset button is used to reboot and
re-initialize the device (press once
quickly), or for clearing configuration
settings back to factory default values
(press for longer than 3 seconds).
2-2 Front Panel LEDs
The following figure shows the front view of the BLW-04G.
The LEDs on the front panel indicate the status of the unit. You can easily view
the operation of your BLW-04G from this panel.
