- 13 -
connection between the CPE (end-user side) and DSLAM (ISP side). If
your ISP uses PPTP to establish the connection, you should select this
item and follow the steps below.
y
Internet IP Address
Enter the IP address provided by your ISP. If
your ISP provides you an Alcatel Speed Touch
TM
modem, it is
suggested that you enter 10.0.0.150 in this column.
y
Subnet Mask
Enter the subnet mask values provided by your ISP.
y
Gateway
Your ISP will provide you with the Default Gateway IP
Address. If your ISP provides you an Alcatel Speed Touch
TM
modem,
it is suggested that you enter the 10.0.0.138 in this column.
y
User Name
Enter the user name provided by your ISP.
y
Password
Enter the password provided by your ISP.
y
Connect-on-demand
is
a utility used to trigger the PPTP session
when there is packet being sent through the WAN port while it is on
disconnected situation. Check the radio button to make this function
active, and then you must enter the number of minutes you wish the
network to remain idle before disconnection occurs in the “
Max Idle
Time”
location. Note that this function is for PPTP only.
y
Keep Alive
This function keeps your PPTP connection enable even if
it remains idle. However, in some situation, PPTP session cannot be
established immediately after disconnection. This is because the
system on the ISP’s site may need a little time to restore itself. You
may need to check with your ISP to obtain detail of how long you need
to wait before re-establish the PPTP session. Enter this information in
the “
Redial Period
” field.
When you have properly configured the Setup page, click “
Apply”
. You can
now test to see if the settings are all correct by attempting to connect to the
Internet.
