User’s Manual of WGSD-1022/WGSD-8000
- 228 –
Console (config)#
interface vlan
2
Console (config-if)#
ip igmp snooping mrouter-time-out
200
5.9.6 ip igmp snooping leave-time-out
The
ip igmp snooping leave-time-out
command configures the leave-time-out. If an IGMP report for a multicast group is not
received within the leave-time-out period after an IGMP leave was received from a specific port, the current port is deleted from
the member list of that multicast group. To configure the default leave-time-out, use the
no
form of this command.
Syntax
ip igmp snooping leave-time-out
{
time-out | immediate-leave}
no ip igmp snooping leave-time-out
time-out
— leave-time-out in seconds. (Range: 0 - 2147483647)
immediate-leave
— Specifies that the port should be immediately removed from the members list after receivingIGMP
Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
The leave timeout should be set greater than the maximum time that a host is allowed to respond to an IGMP Query.
Use
immediate leave
only where there is only one host connected to a port.
Example
The following example configures the host leave-time-out to 60 seconds.
Console (config)#
interface vlan 2
Console (config-if)#
ip igmp snooping leave-time-out 60
5.9.7 show ip igmp snooping mrouter
The
show ip igmp snooping mrouter
User EXEC command displays information on dynamically learned multicast router
interfaces.
Syntax
show ip igmp snooping mrouter
[
interface vlan-id
]
