GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
With Dynamic Routing, you can enable the Router to automatically adjust to physical changes in
the network’s layout. The Cable/DSL Firewall Router, using the RIP protocol, determines the
network packets’ route based on the fewest number of hops between the source and the
destination. The RIP protocol regularly broadcasts routing information to other routers on the
network.
You can setup 20 sets of static route in static command. After entering
static
menu, the screen will
show as follow:
>> add
Add static route entry
delete
Delete static route entry
List
Show static routing table
You can add 20 sets of static route entry by using
add
command. Type the IP information of the
static route including IP address, subnet mask and gateway.
You can delete the static route information via
delete
command.
You can review the static route entry by using list command.
To configure Routing Information Protocol (RIP), you can use
rip
command to setup the
parameters. Move the cursor “
>>
” to
rip
and press enter.
>> generic
Configure operation and auto summery mode
lan
Configure LAN interface RIP parameters
wan
Configure WAN interface RIP parameters
list
Show RIP configuration
Generic
command can setup RIP mode and auto summery mode.
If there are any routers in your LAN, you can configure LAN interface RIP parameters via
lan
command.
The product supports 8 PVCs and you can configure the RIP parameters of each WAN via
wan
command. Move the cursor “
>>
” to
wan
and press enter.
----------------------------------------------------------------------
Command: setup route rip wan <1~8> <more...>
Message: Please input the following information.
Active interface number <1~8>:
1
----------------------------------------------------------------------
The screen will prompt as follow:
>> attrib
Operation, authentication and Poison reverse mode
version
RIP protocol version
authe
Authentication code
Attrib
command can configure RIP mode, authentication type and Poison reverse mode.
Version
command can configure RIP protocol version.
140
Summary of Contents for G.SHDSL.bis Bridge Router GRT-504
Page 1: ...4 Wire G SHDSL bis Firewall Router GRT 504 User s Manual...
Page 12: ...GRT 504 4 Wire G SHDSL bis Firewall Router User s Manual 1 3 Applications 11...
Page 24: ...GRT 504 4 Wire G SHDSL bis Firewall Router User s Manual 23...
Page 25: ...GRT 504 4 Wire G SHDSL bis Firewall Router User s Manual 24...