Planet G.SHDSL.bis Bridge Router GRT-504, User Manual

Page: 135 / 152

GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
7.12 Setup
All of the setup parameters are located in the subdirectories of setup. Move the cursor “
>> “ to
setup and press enter.
>> mode Switch system operation mode
shdsl.bis Configure SHDSL.bis parameters
wan Configure WAN interface profile
bridge Configure transparent bridging
vlan
stp
Configure virtual LAN parameters
Configure bridge STP parameters
route Configure routing parameters
lan Configure LAN interface profile
ip_share Configure NAT/PAT parameters
firewall
ip_qos
Configure Firewall parameters
Configure IP QoS parameters
dhcp Configure DHCP parameters
dns_proxy Configure DNS proxy parameters
hostname Configure local host name
default Restore factory default setting
7.12.1 Mode
The product can act as routing mode or bridging mode. The default setting is routing mode. You
can change the system operation mode by using mode command. Move the cursor “
>> “ to mode
and press enter.
----------------------------------------------------------------------
Command: setup mode <Route|Bridge>
Message: Please input the following information.
System operation mode (TAB select) <Route>:
Route
----------------------------------------------------------------------
7.12.2 SHDSL.bis
You can setup the SHDSL.bis parameters by the command
shdsl.bis . Move the cursor “ >> “ to
shdsl.bis and press enter.
mode Configure SHDSL.bis mode
Link Configure SHDSL.bis link
`>>
n*64 Configure SHDSL.bis data rate
type Configure SHDSL.bis annex type
clear Clear current CRC error count
margin
tcpam
Configure SHDSL.bis SNR margin
Configure shdsl.bis TCPAM type
There are two types of SHDSL.bis mode, STU-C and STU-R. STU-C means the terminal of central
office and STU-R means customer premise equipment.
Link type will be 2-wire, M-Pair, M-Pair (Conexant), Auto_Fall_Back, StandBy, and Multi-link.
4-wire product can be worked under 2-wire mode.
134