CardBus 10/100Mbps Ethernet Card
39
[Error 9]
"Unknown parameters."
CARDGO.EXE Syntax error.
Correction :
Refer to the default syntax listed above and correct it.
[Error 10]
"Invalid value !"
An invalid parameter value was issued.
Correction :
Refer to the valid settings listed above and correct it.
[Error 11]
"Card Service Driver is not loaded."
"Please load the Card & Socket Service Drivers first, or use
"ENABLER.EXE" to enable the card directly."
Correction :
As the description of the error message indicates.
[Warning 1]
"
ENW-3502-FC
Client Driver is already resident."
CARDGO.EXE has already been executed.
Correction :
If you want to change the parameter setting, reboot
your system.
[Warning 2]
"Please insert
ENW-3502-FC
."
The
ENW-3502-FC
is not detected.
Correction :
Insert the card.
ENABLER.EXE
Here is the list of error messages the ENABLER.EXE may display and
correction method we suggested :
**** PCI BIOS not detected !
PCIBIOS Ver 2.1 or higher is not present.
Correction :
Please contact your Notebook vendor.
**** Unable to locate any PCI-to-CardBus Bridges
Cannot detect any PCI-to-CardBus bridge.
Correction:
Make sure your notebook is equipped with CardBus
controller. If it is not, please contact your Notebook vendor.
**** Please insert
ENW-3502-FC
.
The card is not detected.
Correction :
Insert the card.
**** The BIOS does not assign a PCI IRQ for the card. Use ‘ -is’ option to
set ISA IRQ routing.
Correction :
Use ‘ -is’ option.
