pag. 24
Note:
When you install a new version of the software, if it is the first time it is better to do the update of the Firmware in the CNV510-PBUS-RTU device.
Note:
When you receive the device, for the first time, you also have to update the Firmware in the CNV510-PBUS-RTU device.
Warning:
If the Fig. 11 appears when you try to do the update try these points:
Try to repeat the operations for the updating;
Try with another PC;
Try to restart the PC;
If you are using the program inside a Virtual Machine, try to use in the main Operating System;
If you are using Windows Seven or Vista or 8/10, make sure that you have the administrator privileges;
Take attention at Firewall lock;
Check the LAN settings.
Check the Wi-Fi settings;
If you are using the program inside a Virtual Machine, try to use in the main Operating System;
If you are using Windows Seven, Vista, 8 or 10 make sure that you have the administrator privileges;
In case you have to program more than one device, using the "
UDP Update
", you have to cancel the ARP table every time you connect a new device on Ethernet. For
do this you have to launch the "Command Prompt" and write the command "
arp -d
". Pay attention that with Windows Vista, Seven, 8 you have to launch the
"Command Prompt" with Administrator Rights;
Figure 11: “Protection” window
Summary of Contents for CNV510-PBUS-RTU-A
Page 4: ...pag 4 MECHANICAL DIMENSIONS...
Page 5: ...pag 5 EXAMPLE OF CONNECTION...
Page 6: ...pag 6 CONNECTION SCHEME...
Page 7: ...pag 7 POWER SUPPLY...
