Setting the Flash Trigger
Slide the Power Switch to ON, and the device is on and status indicator lamp will not
reveal.
Note:
In order to avoid power consumption, turn off the transmitter when not in use.
Power Switch
1.
The system will automatically enter standby mode after stop operating the
transmitter over 60 seconds. And the displays on the LCD panel disappear now.
2.
Press any button to wake up. If the flash trigger is attached to the hot shoe of
CANON EOS camera, half press the camera shutter can also wake the system up.
Note:
If do not want to enter power saving mode, press the <MENU> button to enter C.Fn custom
settings and set STBY to OFF.
Automatically Enter Power Saving Mode
Slide the AF-assist beam switch to
ON
, and the AF lighting is allowed to output.
When the camera cannot focus, the AF assist beam will turn on; when the camera can
focus, the AF assist beam will turn off.
Power Switch of AF Assist Beam
Channel Setting
Change the wireless channels and wireless ID to avoid interference for it can only be
triggered after the wireless IDs and channels of the master unit and the slave unit are
set to the same.
Press the <
MENU
> button to enter C.Fn ID. Press the <
SET
> button to choose OFF
channel expansion shutdown, and choose any figure from 01 to 99.
Note: It can only be used when the slave units have the wireless ID settings functions. If they do not
have, please set the ID to OFF.
Wireless ID Settings
Mode Setting
1.
After pressing the group button to select one
group, press the <
MODE
> button and all the current
group’s mode will be changed by the order of
TTL/M/--
.
2.
In normal situation, press the <
MODE
> button to
switch the multi-group mode to MULTI mode. Press
the group selection button and then press the
<MODE> button can set the MULTI mode to ON or
OFF.
Setting the Flash Trigger
CH 01
A
B
C
M
1
/128
CH 01
A
B
C
ON
1
/128
ON
1Hz
1Times
-
08
-
1.
Short press the <MENU> button and choose CH to set the channel value.
2.
Turn the select dial to choose the appropriate channel. The channel value will be
confirmed after exiting the menu.
3.
This flash trigger contains 32 channels which can be changed from 1 to 32. Set
the transmitter and the receiver to the same channel before usage.
-
07 -
