Using the Flash Trigger
3. As a Wireless Original Flash Trigger
Take 600EX-RT as an example:
3.1
Turn off the camera and mount the transmitter
on camera hotshoe. Then, power on the flash
trigger and the camera.
3.2
Short press the <MENU> button to set channel,
group, mode and parameters (refers to the
contents of “Setting the Flash Trigger”).
3.3
Attach the original flash to the
ST-III R-C
receiver.
Press the <
CH
> button on the receiver to set
the same channel to the flash trigger, and press
the <
Gr
> button to set the same group to the
flash trigger (Note: please refer to the relevant
instruction manual when setting the original
camera flashes).
3.4
Press the camera shutter to trigger. And the
status lamp of the camera flash and the flash
trigger both turn red synchronously.
GR
CH
<
GR/CH
> button to set the same channel to the flash trigger, and short press
the <
GR/CH
> button to set the same group to the flash trigger (Note: please
refer to the relevant instruction manual when setting the oudoor flashes of other
models).
2.4
Press the camera shutter to trigger and the status lamp of the flash trigger turns
red synchronously.
Using the Flash Trigger
4. As a Wireless Studio Flash Trigger
Take
LUMI
400II as an example:
4.1
Turn off the camera and mount the transmitter
on camera hotshoe. Then, power on the flash
trigger and the camera.
4.2
Short press the <MENU> button to set
channel, group, mode and parameters (refers
to the contents of “Setting the Flash Trigger”).
4.3
Connect the studio flash to power source and
power it on. Synchronously press down the
<G
R/CH
> button and <
S1/S2
>button and the
wireless icon will be displayed on the
LCD panel. Long press the <
GR/CH
> button to
set the same channel to the flash trigger, and
short press the <
GR/CH
> button to set the
same group to the flash trigger (Note: please
refer to the relevant instruction manual when
setting the studio flashes of other models).
4.4
Press the camera shutter to trigger. And the
status lamp of the camera flash and the flash
trigger both turn red synchronously.
Note:
As the studio flash’s minimum output value is
1/32, the output value of the flash trigger should
be set to or over 1/32. As the studio flash do not
have TTL and stroboscopic functions, the flash
trigger should be set to M mode in triggering.
CH
%
< >
-
18
-
-
17
-
