Piusi V100, Instructions For Installation, Use And Maintenance Manual, Page: 39 / 64

39
/124 39
/60
EN
This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.
Translated from Italian
NOTICE NOTICE: the system goes into standby mode by switching off all 3
LEDs 1 minute a‚er the end of the last operation.
Status Led
Status
green LED Yellow LED Red LED
Off Off Off Stand-by phase
Flashing Off Off Insufficient voltage alarm
On Off Off Power is normally present
On Off On Pump is ON
On Off Rapid Flashing
Rapid flashing: Maximum current
exceeded alarm
On Off Slow Flashing
Slow flashing: Maximum temperature
exceeded alarm
On On Off Level alarm
On Flashing Off
Failure-to-prime alarm
- when dispensing begins (empty tubes)or
- when dispensing ends due to lack of
fluid
Flashing Flashing Off
Piloting fault of motor MOS n°1: contact
technical assistance ASAP
On Flashing Flashing
Piloting fault of motor MOS n°2: contact
technical assistance ASAP