Pitney Bowes F767, Operator'S Manual

Page: 54 / 66

4-6 SDC927D
4 • Troubleshooting & Maintenance
Problem Possible Cause
Material stops
in the F767
accumulation area.
Display prompts
'Double feed error'.
Check the Accumulator Side Guide settings (see
page 2-6) and the Ramp settings (see page 2-15).
Wrong program selected from listing.
Material stops in
the separation
area. Display
prompts 'Double
feed error'.
The F767 has detected a 'Double Feed'. Push the
Stop/Clear Deck button to advance the material
into the accumulator area for error correction. If
double feeds persist, refer to the Feeder Head
adjustment on page 2-14.
Multiple feed
errors or stream
feed errors.
Check the Feeder Head adjustment
(see page 2-13).
Feeder display
indicates 'DF
Sensor Out of
Limit'.
The material is too thick to be sensed by the double
detection system.
Check that you have selected the correct program
(see page 2-4).
Check that the job is programmed correctly i.e.
'Paper' or 'Booklet' (if appropriate) selected in
material selection to turn double detect off (see
pages 3-2, 3-5 or 3-11).
Feeder display
indicates
'Current Job Not
Compatible'.
Check the job setups on the F767 Document
Feeder AND the material listed for feeder Y on the
DI900/DI950 Inserter to ensure that both have the
same material type and loading orientation.
If scanning is being used, check it is selected in
both the F767
AND
the DI900/DI950 programs.
Feeder display
indicates 'No
Material for Double
Feed Adjustment'.
Take a single sheet and load it onto the F767 Feed
Deck (see page 2-5).
Material not being transported to Take-Away Roller.
Adjust Feeder Head settings (see page 2-13).
Feeder display
indicates 'Wrong
Accumulation
Direction'.
Check the position of the Accumulator Ramp (see
page 2-2).