SDC927D
3-11
Programming • 3
Step by Step Instructions
With the feeder ON, press the
Green
,
Blue
and
Red
buttons at the same
time. The display will show:
Programming a
'BCR Standard'
Job
Select: NEW NON-SCANNING JOB
<-->=SELECT Green=Confirm Blue=EXIT
Press the
Arrow Buttons
to select ‘NEW SCANNING JOB’.
Select: NEW SCANNING JOB
<-->=SELECT Green=Confirm Blue=EXIT
Press the
Green
button to enter the scanning programming mode. The
display will show the program naming screen:
019> Name of new program : --------
<-->=ALPHA Green=CONFIRM Red=GO ON
019> Material: PAPER/DF
<-->=SELECT Green=CONFIRM Blue=EXIT
You can enter a program name up to eight characters long, using any
combination of alpha and numeric characters.
Use the
Arrow Buttons
until the first character of your program name
appears.
Press the
Green
button to confirm each character.
When the name is complete, press
Red
to continue.
The display shows the material selection screen:
Use the
Arrow Buttons
to select the material for this job:
Summary of Contents for F767
