Section One: ASSEMBLY INSTRUCTIONS
Installation Steps
Parts Needed:
ASSEMBLING THE LID HANDLE
Hardware Required:
5 Lid Handle
6 Decorative
Washers x 2
( Bezels )
Insulation Cardboard
Parts Needed:
Smoke Stack
Smoke Stack Gasket
ATTACHING THE SMOKE STACK
- (820S/820SC ONLY)
Insert one screw (A) from inside the lid, through the hole
provided in the lid.
Place one Bezel (6) over the screw, then line-up the
handle (5) with the threaded end of the screw.
Hand start the screw into the handle,
Repeat procedure for other end of handle.
Using your wrench securely tighten ALL screws (A)
Hardware Required:
Using the 2 screws (AA) insert them through the stack section, through the gasket, then finally through the
barrel end.
Hand start, then secure in place using your Phillips Screwdriver.
NOTE:
DO NOT lower the chimney cap tight to chimney stack. You must allow air to escape.
2
Screw 1/4”- 20* 3/5” x 2 (AA)
Screw 1/4”- 20* 3/5” x 2 (AA)
Installation Steps
Page 12
Parts Needed:
ASSEMBLING—LID STOPPER
Installation Steps
Slip the Lid Stopper front lip into the slot provided
Located at the top of the barrel in the middle.
Using the screw driver, secure the Lid Stopper
to the barrel with one 1/4” - #20 x 3/5” (AA) screw.
Take care not to over-tighten.
Hardware Required:
Screw 1/4”- 20* 3/5” x 1 (AA)
ASSEMBLING THE REMAING COMMON COMPONENTS
