Section One: ASSEMBLY INSTRUCTIONS
ATTACHING LEG AND GRILL ASSEMBLY: - for S models only
Tools Required:
1– #2 Phillips Screwdriver
Installation Steps
Page 8
Hardware Required:
1 x Completed Leg Assembly
1 x # 4 Pit Boss Main Body
16 x Screws 1/4” - 20 (AA)
WARNING!
Due to the size and weight of
the upper grill, the following
installation step is a two (2)
person job.
NOTE:
Damaged caused due to ignoring
warning or improper installation is
NOT a warranty issue.
Step 1 Attach The Grill And Leg Assembly
Carefully lift the Barrel Smoker up and unto the Leg assembly.
Note:
This may require 2 people.
The Barrel Smoker will slide down and over the leg assembly.
OR
Carefully stand the grease spout end of the barrel on a protective
floor covering. Then insert the legs into the barrel. This makes a
single person installation much easier.
Starting at one leg:
Line up the pre-drilled and clinch nut installed holes on the leg,
(see diagram for location), and the punched holes on the side of the
smoker. There are two (2) on the front and on the side of each leg.
Using a Phillips head driver, install 4 of the supplied 1/4”-20
Screws (AA) into each leg, to secure each leg to the Barrel.
NOTE: It is best to start each threaded screw by hand, to
ensure the thread DOES NOT cross thread or strip.
When one leg is complete, continue the same steps. On the remaining 3
legs.
Note:
If you have the Pit Boss Model SC, that comes complete with the Cart Enclosure kit, please proceed to the next
page.
PROCEED TO PAGE 12
