Piper PA-28-236 DAKOTA, Pilot Operating Handbook

Page: 247 / 367

PIPER AIRCRAFT CORPORATION SECTION 8
PA-28-236, DAKOTA HANDLING, SERV & MAINT
ISSUED: JUNE 1, 1978 REPORT: VB-910
8-17
(3) Allow the solvent to remain on the gear from five to ten
minutes. Then rinse the gear with additional solvent and
allow to dry.
(4) Remove the cover from the wheel and remove the catch
pan.
(5) Lubricate the gear in accordance with the Lubrication
Chart in the PA-28 Service Manual.
(c) Cleaning Exterior Surfaces
The airplane should be washed with a mild soap and water.
Harsh abrasives or alkaline soaps or detergents could make
scratches on painted or plastic surfaces or could cause corrosion of
metal. Cover areas where cleaning solution could cause damage. To
wash the airplane, use the following procedure:
(1) Flush away loose dirt with water.
(2) Apply cleaning solution with a soft cloth, a sponge or a
soft bristle brush.
(3) To remove exhaust stains, allow the solution to remain on
the surface longer.
(4) To remove stubborn oil and grease, use a cloth dampened
with naptha.
(5) Rinse all surfaces thoroughly.
(6) Any good automotive wax may be used to preserve painted
surfaces. Soft cleaning cloths or a chamois should be used
to prevent scratches when cleaning or polishing. A heavier
coating of wax on the leading surfaces will reduce the
abrasion problems in these areas.
(d) Cleaning Windshield and Windows
(1) Remove dirt, mud and other loose particles from exterior
surfaces with clean water.
(2) Wash with mild soap and warm water or with aircraft
plastic cleaner. Use a soft cloth or sponge in a straight
back and forth motion. Do not rub harshly.