Using other functions
09
78
En
Checking your system settings
Use the status display screen to check the various
settings you’ve made for features such as sound delay,
digital noise reduction, and high-sampling.
1
From the remote control receiver menu, press
STATUS to check the system settings.
You may need to press
on the Home menu (
)
first before reaching the receiver menu screen shown
below (use the
/
(cursor left/right) soft keys to go to
the previous/next menu screen).
These appear on both the OSD and the front panel
display.
The front panel display shows each of the following
settings for two seconds each:
Note
• If the Stream Direct mode is switched on, some
settings above will show
OFF
, even though they are
switched on.
2
When you’re finished, press STATUS again to
switch off the display.
Resetting the system
Use this feature to reset the system to its factory default
settings (see
Default receiver settings
below).
1
Switch the receiver into standby.
2
While holding down the front panel DIGITAL NR
button, press and hold
STANDBY/ON for about
three seconds.
The display shows
RESET?
.
3
Press the front panel button.
The display shows
OK?
.
4
Within 5 seconds, press OPTION –.
The receiver should now be reset.
Note
• This doesn’t affect the presets that you have
programmed into the remote control (see
Using the
remote control with other components
on page 66).
See
Resetting the remote control
on page 10 to do
this.
Default receiver settings
The table below shows the factory default settings. When
you reset the system, the receiver reverts to these
defaults:
Surround back speaker/
Virtual back speaker
Video select
Acoustic calibration EQ
Dual mono
Digital noise reduction
Sound delay
Midnight
Hi-bit
Loudness
High-sampling
Tone
Real phantom
RECEIVER
RECEIVER
3/3
SB CH
MODE
INPUT
STATUS
INPUT
ATT
SPEAKER
A/B
VIDEO
SELECT
TAPE2
MONITOR
DISPLAY
DIMMER
RECEIVER
TV
CONT
SB CH MODE :
ACOUS. CAL EQ
:
DIGITAL NR :
MIDNIGHT
:
LOUDNESS :
TONE CONTROL :
VIDEO SELECT :
DUAL MONO :
SOUND DELAY :
HI-BIT :
HI-SAMPLING :
REAL PHANTOM :
ALL ADJ
OFF
ON
DVD/LD
CH1
0.0frame
OFF
OFF
OFF
OFF
OFF
OFF
Setting type
Default setting
Page ref.
Input
DVD/LD
Master volume
– – – dB
(no sound)
Listening mode
STANDARD
(video inputs,
multichannel inputs, USB)
STEREO
(audio inputs)
page 41
Advanced surround
effect level
90
(
5/7CH STEREO
)
50
(all other modes)
page 43
Listening mode (w/
headphones)
STEREO
page 44
Stream Direct mode
SD:1 NORMAL
(
ON
)
page 45
Acoustic Calibration
EQ
OFF
(switches to
ALL CH ADJ
after the Auto Surround Setup)
page 46
Input signal select
AUTO
except multichannel
inputs (
ANALOG
) and USB
(
DIGITAL
)
page 46
USB / multichannel
input channel setting
8
channels
page 47
Surround Back
Channel mode
ON
(with surround back
speaker(s) connected)
page 48
Virtual Surround Back
mode
OFF
page 49
Hi-bit/Hi-sampling
OFF
page 50
