Additional information
09
38
En
Resetting the main unit
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front
panel controls to do this.
1
Switch the receiver into standby.
2
While holding down the
ADVANCED
SURROUND
button, press and hold the
STANDBY/ON button for about three
seconds.
3
When you see RESET? appear in the
display, press the ‘
ST –
’ button.
OK?
shows in the display.
4
Press
SOUND RETRIEVER
to confirm.
OK
appears in the display to indicate that the
receiver has been reset to the factory default
settings.
No sound from subwoofer.
• Make sure the subwoofer is switched on.
• If the subwoofer has a volume knob, make sure it’s turned up.
• The Dolby Digital or DTS source you are listening to may not have
an LFE channel.
• Switch the subwoofer setting in
Speaker setting
on page 31 to
YES
or
PLUS
.
• Switch the
LFEATT (LFE Attenuate)
on page 29 to
LFEATT 0
or
LFEATT 10
.
The
PHASE CONTROL
feature
doesn’t seem to have an
audible effect.
• If applicable, check that the lowpass filter switch on your
subwoofer is off, or the lowpass cutoff is set to the highest frequency
setting. If there is a
PHASE
setting on your subwoofer, set it to 0º (or
depending on the subwoofer, the setting where you think it has the
best overall effect on the sound).
• Make sure the speaker distance setting is correct for all speakers
(see
Speaker Distance
on page 32).
Noise during playback of a
cassette deck.
• Move the cassette deck further from your receiver, until the noise
disappears.
No sound is output or a noise
is output when software with
DTS is played back.
• Set the digital volume level of the player to full, or to the neutral
position.
During a playback search,
noise is output from a DTS
compatible CD player.
• This is not a malfunction, but be sure to turn the volume down to
prevent the output of loud noise from your speakers.
Can’t operate the remote
control.
• Replace the batteries (refer to page 23).
• Operate within 7 m (23 ft.), 30° of the remote sensor on the front
panel (refer to page 5).
• Remove the obstacle or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
The display is dark or off.
• Press
DIMMER
on the remote repeatedly to return to the default.
Problem
Remedy
VSX_518_KU.book 38 ページ ２００８年５月１５日 木曜日 午後６時３１分
