51
En
Remote Control of Other Components
OPERA
TION
5
Press the
2
/
3
buttons to choose the
component and then press the
5
/
∞
buttons to display the name of the
component’s manufacturer.
Most manufacturers have been programmed into the
amplifier, but if your component is made by a small or
relatively unknown manufacturer you may not be able
to find it.
6
Point the remote toward the component to
be controlled, and enter the 3 digit setup
code.
When you enter the setup code, the remote emits a
power ON/OFF signal. If the component turns ON or
OFF, you have entered the proper code.
If the component does not turn ON or OFF and there
is more than one setup code, try inputting another
code. Some manufacturers use several sets of remote
control signals and the first code may not correspond
to your component.
Repeat steps 4 through 6 to assign preset codes
for as many components as necessary.
If you can’t get your component to respond to any
of the codes you can still program the component
into the remote control using the procedure in the
next section.
7
Press the REMOTE SETUP button to exit
the PRESET RECALL SETUP mode.
The remote control and TV return to their previous
operation modes.
This method should help you customize the remote
control for your system.
To go back a screen
press EXIT
To exit the process
press EXIT repeatedly.
ENTER
TV/SAT
VCR1
VCR2
MUT
SYSTEM
OFF
MULTI
OPERATION
STANDBY/ON
5
AMP
DVD/LD
TV/SAT
VCR1
VCR2
REMOTE
SETUP
MD/TAPE1
CD
LINE/
TUNER
TV
CONTROL
1
2
4
7
8
9
5
6
3
0
Preset Recall
EXIT
MD/TAPE1]
[
INPUT
CODE NUMBER
0 0 0
SEE INSTRUCTION MANUAL
7
6
