Connecting your equipment
03
12
En
11 AM and FM antenna terminals
Use to connect indoor or outdoor antennas for radio
broadcasts.
Connecting antennas
on page 20.
12 Multichannel pre-amplifier outputs
Use to connect separate amplifiers for front, center,
surround, surround back and subwoofer channels.
Connecting additional amplifiers
on page 50 (see also
Installing your speaker system
on page 18 for powered
subwoofer connection).
13 Composite and S-video monitor outputs
Use to connect monitors and TVs.
Connecting your TV and DVD player
on page 13.
14 Multichannel analog audio inputs
7.1 channel inputs for connection to a DVD player with
multichannel analog outputs.
Connecting the multichannel analog inputs
on
page 48.
15 12 V trigger jack
(total 50 mA max.)
Use to switch components in your system on and off
according to the input function of the receiver.
Switching components on and off using the 12 volt
trigger
on page 52.
16 MULTI-ZONE and source outputs
Use to connect a second amplifier in a separate zone.
MULTI-ZONE listening
on page 50.
17 SIRIUS Radio input
Using SIRIUS Radio
on page 46.
18 Speaker terminals
Use for connection to the main front, center, surround
and surround back speakers.
Installing your speaker system
on page 18.
19 Switched AC power outlet
(100 W/0.8 A max.)
Use to power another component in the system. Power to
the outlet switches on and off with the receiver.
AC outlet
on page 21.
When making cable connections
• To avoid hum, do not lay connected cables over the
top of the receiver.
• When connecting optical cables, be careful when
inserting the plug not to damage the shutter
protecting the optical socket.
• When storing optical cable, coil loosely. The cable
may be damaged if bent around sharp corners.
About the video converter
When the video converter is enabled, all analog video
sources are output through all of the
MONITOR VIDEO
OUT
jacks (HDMI and component video cannot be
converted).
1
See
Video Converter Setup
on page 57 to
switch the video converter on or off.
If several video components are assigned to the same
input function (see
The Input Assign menu
on page 55),
the converter gives priority to component, S-video, then
composite (in that order).
• For optimal video performance, THX recommends
switching video conversion (in
Video Converter Setup
on page 57)
OFF
.
Note
1 You must connect your monitor/TV to the receiver’s HDMI/component video outputs when connecting these video sources. If the video signal does not
appear on your TV or plasma display, try adjusting the resolution settings on your component or display. Note that some components (such as video game
units) have resolutions that may not be converted. In this case, use an (analog) S-video or composite connection.
This product incorporates copyright protection technology
that is protected by U.S. patents and other intellectual
property rights. Use of this copyright protection
technology must be authorized by Macrovision
Corporation, and is intended for home and other limited
consumer uses only unless otherwise authorized by
Macrovision. Reverse engineering or disassembly is
prohibited.
VSX-90TXV_KU.book Page 12 Friday, March 16, 2007 5:46 PM
