En
31
03
Connecting your equipment
Switching components on and
off using the 12 volt trigger
You can connect components in your system
(such as a screen or projector) to this receiver
so that they switch on or off using 12 volt
triggers when you select an input function.
However, you must specify which input func-
tions switch on the trigger using the
The Input
Setup menu
on page 34 . Note that this will only
work with components that have a standby
mode.
RS-232C
MONITOR
OUT
ZONE2
OUT
EXTENSION
SPEAKERS
FM UNBAL 75
AM LOOP
ANTENNA
(OUTPUT 5 V
150 mA MAX)
CONTROL
IR
OUT
IN
OUT
IN 1
IN 2
2
1
12 V TRIGGER
(OUTPUT 12 V
TOTAL 150 mA MAX)
12 V TRIGGER
INPUT
%
Connect the 12 V TRIGGER jack of this
receiver to the 12 V trigger of another
component.
Use a cable with a mono mini-plug on each end
for the connection.
After you’ve specified the input functions that
will switch on the trigger, you’ll be able to
switch the component on or off just by pressing
the input function(s) you’ve set on page 34.
Note
!
It is also possible to have the component
switch not when the input function is
switched, but when
HDMI OUT
is switched.
For details, see
HDMI Setup
on page 53 .
Plugging in the receiver
Only plug in after you have connected all your
components to this receiver, including the
speakers.
CAUTION
!
Handle the power cord by the plug part. Do
not pull out the plug by tugging the cord, and
never touch the power cord when your hands
are wet, as this could cause a short circuit or
electric shock. Do not place the unit, a piece of
furniture, or other object on the power cord or
pinch the cord in any other way. Never make
a knot in the cord or tie it with other cables.
The power cords should be routed so that they
are not likely to be stepped on. A damaged
power cord can cause a fire or give you an
electric shock. Check the power cord once in a
while. If you find it damaged, ask your nearest
Pioneer authorized independent service
company for a replacement.
!
Do not use any power cord other than the one
supplied with this unit.
!
Do not use the supplied power cord for any
purpose other than that described below.
!
The receiver should be disconnected by
removing the mains plug from the wall
socket when not in regular use, e.g., when on
vacation.
!
Make sure the blue
u
STANDBY/ON
light has
gone out before unplugging.
1 Plug the supplied power cord into the
AC IN socket on the back of the receiver.
2 Plug the other end into a power outlet.
!
After this receiver is connected to an AC
outlet, a 2 second to 10 second HDMI
initialization process begins. You cannot
carry out any operations during this process.
The
HDMI
indicator in the front panel display
blinks during this process, and you can turn
on this receiver once it has stopped blinking.
When you set the
Control
with HDMI to
OFF
,
you can skip this process. For details about
the
Control
with HDMI feature, see
Control
with HDMI function
on page 53 .
Summary of Contents for Elite SC-55
Page 1: ...SC 57 SC 55 ...
Page 107: ...107 En 13 Additional information ...