Pioneer DVR-440HX-S, Operating Instructions And Owner'S Manual

Page: 24 / 172

Connecting up 02
24
En
Connecting using HDMI
If you have an HDMI or DVI-equipped
1
monitor or display
2
, you can connect it to
this recorder using an HDMI cable (not
supplied).
The HDMI connector outputs uncom-
pressed digital video, as well as almost every
kind of digital audio.
1 Use an HDMI cable to connect the
HDMI OUT connector on this recorder to
an HDMI connector on an HDMI-compat-
ible monitor.
• The arrow on the cable connector body
should be face down for correct align-
ment with the connector on the
recorder.
When connected to an HDMI component or
HDCP-compatible DVI component, the
HDMI indicator lights.
HDMI setup is generally automatic. There
are however settings you can change if you
need to. See
HDMI Output (only available
when an HDMI device is connected) on
page 148 for more information. Note that the
HDMI settings remain in effect until you
change them, or connect a new HDMI
component.
Important
• An HDMI connection can only be made
with DVI-equipped components compat-
ible with both DVI and High-bandwidth
Digital Content Protection (HDCP). If you
choose to connect to a DVI connector,
you will need a DVI to HDMI adaptor
cable. A DVI to HDCP connection,
however, does not support audio.
Consult your local audio dealer for more
information.
• The HDMI connection is compatible with
32 kHz, 44.1 kHz, 48 kHz, 96 kHz, 16 bit/
20 bit/24 bit 2-channel linear PCM
signals, as well as Dolby Digital, DTS and
MPEG audio bitstream.
• If your connected component is only
compatible with Linear PCM, the signal
is output as Linear PCM (DTS audio is
not output).
• If you have connected to a Pioneer
plasma display, please select the HDMI
setup on the display (refer to the
supplied manual for more on this).
Note
1 This unit has been designed to be compliant with HDMI (High Definition Multimedia Interface) version 1.2a and
HDCP version 1.1. Depending on the component you have connected, using a DVI connection may result in
unreliable signal transfers.
2 The pixel resolution of this recorder’s HDMI video output is (according to TV format): NTSC (720 x 480i/p, 1280
x 720p, 1920 x 1080i, DVR-940HX-S only: 1920 x 1080p) and PAL (720 x 576i/p, 1280 x 720p, 1920 x 1080i,
DVR-940HX-S only: 1920 x 1080p). If your display is not compatible with these resolutions the picture may not be
correctly reproduced.
HDMI-compatible display
HDMI OUT
ANTENNA
IN
OUT
DIGITAL
AUDIO OUT
COAXIAL
ANTENNA
(DIGITAL)
IN
OUT
VIDEO L R
COMPONENT
VIDEO OUT
S-VIDEO
OUTPUT
INPUT3
IN
CONTROL G-LINK
AV 1 (RGB) – TV
AV 2 (INPUT 1/DECODER)
AC IN
COMMON INTERFACE
AUDIO
P B P R Y
HDMI
IN
DVR940HX_UK_EN.book 24 ページ ２００６年７月１２日 水曜日 午後４時５分