Additional information
08
45
En
Note
• Using the
16:9 (Wide)
setting with a
standard 4:3 TV, or either of the 4:3 settings
with a widescreen TV, will result in a
distorted picture.
Setting the TV system
The default setting of this player is
AUTO
, and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to
AUTO
. If you experience picture distor-
tion with some discs, set the TV system to
match your country or region’s system. Doing
this, however, may restrict the kinds of disc you
can watch. The table below shows what kinds
of disc are compatible with each setting
(
AUTO
,
PAL
and
NTSC
).
1
If the player is on, press
STANDBY/
ON to switch it to standby.
2
Using the front panel controls, hold
down
then press
STANDBY/ON to
switch the TV system.
The TV system changes as follows:
•
AUTO
NTSC
•
NTSC
PAL
•
PAL
AUTO
Note
• You have to switch the player into standby
(press
STANDBY/ON
) before each
change.
Resetting the player
Use this procedure to reset all the player’s
settings to the factory default.
1
Switch the player into standby.
2
Using the front panel buttons,
hold down the
(stop) button and press
STANDBY/ON to switch the player back
on.
All the player’s settings are now reset.
Power reset
Use this procedure to switch the power off if
the player is unresponsive to any control from
the front panel or remote.
1
Press and hold the front panel
STANDBY/ON for 10 seconds.
When the power is completely off, you cannot
use the remote to switch it back on again. Use
the front panel
STANDBY/ON
button.
Disc
Player setting
Type
Format
NTSC
PAL
AUTO
DVD/
Super
VCD
NTSC
NTSC
PAL
NTSC
PAL
NTSC
PAL
PAL
Video CD NTSC
NTSC
PAL
NTSC
PAL
NTSC
PAL
PAL
CD/SACD
no disc
—
NTSC
PAL
NTSC or
PAL
DV575A WY_Mid.book 45 ページ ２００４年１月２８日 水曜日 午後６時５３分
