Additional information
09
55
En
English
Settings are canceled.
• When the power is cut due to power failure or by unplugging the
power cord, settings will be canceled: Press
STANDBY/ON
on the
front panel to turn the player off. Wait for
--OFF--
to disappear from the
display, then unplug the power cord.
The remote control
doesn't seem to work.
• The remote control is too far from the player, or the angle with the
remote sensor is too wide: Use the remote within its operating range
(page 18).
• The batteries are exhausted: Put in new ones (page 6).
No picture/No color.
• Incorrect video connections: Check that connections are correct and
that plugs are inserted fully. Also check the video cable for damage.
• TV/monitor or AV amplifier settings are incorrect: Check the
instruction manual of the connected equipment.
• The video output is set to progressive but your TV/monitor is not
compatible with progressive scan: See page 13 for how to set to
Interlace
.
Screen is stretched or
aspect does not change.
• The
TV Screen
setting in the Initial Settings menu is incorrect. See
page 52 for how to set it correctly for your TV/monitor.
Picture disturbance
during playback or the
picture is dark.
• This player is compatible with Macro-Vision System copy guard.
Some discs include a copy prevention signal, and when this type of
disc is played back, stripes etc., may appear on some sections of the
picture depending on the TV. This is not a malfunction.
• Due to the player’s copy protection circuits, connection of this device
through a VCR or an AV selector may prevent recording or cause
picture problems. This is not a malfunction.
No audio, or audio is
distorted.
• No audio is output during slow motion playback or when scanning
discs other than audio CDs and SACDs.
• Some DVD discs do not output digital audio: Switch your amplifier to
the player's analog outputs.
• Check that the disc is free from dust and dirt, and that it is not
damaged (page 51).
• Check that all interconnects are firmly inserted.
• Check that the plugs and terminals are free of dirt, oxide, etc. and
clean if necessary. Also check the cable for damage.
• Make sure the player's output is not connected to the amplifier's
phono (turntable) inputs.
• Check your amplifier/receiver’s settings (volume, input function,
speaker settings, etc.).
The analog audio is OK,
but there appears to be
no digital audio signal.
• Make sure that the
Digital Out
setting is set to
On
(page 39).
• Check that the Dolby Digital, DTS and MPEG out settings (page 39)
are suitable for your amplifier/receiver—check the instruction manual
that came with your amplifier/receiver.
• SACDs and some DVD-Audio discs do not output digital audio.
Listen through the player’s analog audio outputs.
Noticeable difference in
DVD and CD volume.
• This is due to differences in the audio format and is not a
malfunction.
Problem
Remedy
DV600AV_WY_EN.book 55 ページ ２００７年３月１４日 水曜日 午後８時０分
