!
A few seconds after turning the ignition
switch to on or off, the front panel automati-
cally moves. When this happens, your fingers
may become jammed in the panel, so keep
your hands away from it.
!
When removing the front panel, be sure to
hold the corrugated release button on the rear
of the front panel while pulling.
Removing the front panel
1
Press EJECT to open the front panel.
If a disc has been inserted to this unit, press-
ing and holding
EJECT
enable to open the
front panel without ejecting a disc.
2
Press the release button, slide and re-
move the front panel toward you.
Take care not to grip it too tightly or to drop
the front panel and protect it from contact
with water or other fluids to prevent perma-
nent damage.
Release button
3
Put the front panel into the provided
protective case for safe keeping.
Attaching the front panel
1
Make sure the inner cover is closed.
2
Replace the front panel by clipping it
into place.
Resetting the microprocessor
The microprocessor must be reset under the
following conditions:
!
Prior to using this unit for the first time
after installation
!
If the unit fails to operate properly
!
When strange or incorrect messages ap-
pear on the display
%
Press RESET with a pen tip or other
pointed instrument.
RESET
button
Switching the DSP setting
mode
This unit features two operation modes: the 3-
way network mode (NW) and the standard
mode (STD). You can switch between modes
as desired. Initially, the DSP setting is set to
the standard mode (STD).
Before You Start
En
7
English
Section
01
