Pioneer DEH-P80RSII, Operation Manual

Page: 54 / 164

Adjusting subwoofer settings
When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use MULTI-CONTROL to select SW 2.
SW 2
appears in the display.
#
When the subwoofer output is on, you can se-
lect SW 2 .
2 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time
MULTI-CONTROL
is pushed left or
right, cut-off frequencies are selected in the
following order:
50
—
63
—
80
—
100
—
125
—
160
—
200 (Hz)
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each time MULTI-CONTROL is pushed up or
down, subwoofer level increases or decreases.
+6 to
–
24 is displayed as the level is increased
or decreased.
Adjusting low pass filter
attenuation slope
When the subwoofer output is on, you can ad-
just the continuity of sound between speaker
units.
1 Use MULTI-CONTROL to select SW 3.
SW 3 appears in the display.
#
When the subwoofer output is on, you can se-
lect
SW 3
.
2 Push MULTI-CONTROL up or down to
select the phase of subwoofer output.
Push
MULTI-CONTROL
up to select normal
phase and NOR appears in the display. Push
MULTI-CONTROL down to select reverse
phase and REV appears in the display.
3 Push MULTI-CONTROL left or right to
select slope.
Each time
MULTI-CONTROL
is pushed left or
right, slopes are selected in the following
order:
–
18
— –
12
— –
6 (dB/oct.)
Note
When slope of subwoofer and high pass filter are
-12dB , and same cut-off frequency, the phase is
reversed 180 degrees at the cut-off frequency. In
this case, reversing the phase assures improved
sound continuity.
Using the high pass filter
When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are output
from the front or rear speakers.
Muting the speaker units (filters)
You can mute front and rear speaker units (fil-
ters) separately. When speaker units (filters)
are muted, no sound is outputted from those
speakers.
!
Even if the speaker unit (filter) is muted,
you can adjust the muted speaker units (fil-
ters). However, mute is automatically can-
celed when the level is adjusted.
1 Use MULTI-CONTROL to select F.HPF 1
(or R.HPF 1).
F.HPF 1
(or R.HPF 1 ) appears in the display.
Audio Adjustments
En
54
Section
11