30
CX-3311
1
2
3
4
A
B
C
D
E
F
1
2
3
4
3.11 HOW TO REMOVE THE DRIVE LEVER ASSY
1. According to “3.6 HOW TO REMOVE THE CRG MECHANISM ASSY”, remove the CRG Mechanism ASSY.
(Mechanism – Eject status)
2. According to “3.9 HOW TO REMOVE AND INSTALL THE CLAMP ARM ASSY”, remove the Clamp Arm ASSY.
3. Remove the Biasing Spring of Drive Lever (Fig.1) .
4. Slide the Drive Lever in the direction of arrow (eject direction), hold it up in the direction of upper right and remove it (Fig.2).
(Note) When the Drive Lever ASSY is installed, in the state where A-part of Fig.3 is completely moved to the direction of
arrow (*1), first install B-part (Fig.2), install C-part of the Drive Lever (Fig.4) in the groove of Chassis side bend, and
finally install D-part (Fig.4) in the L-shaped groove of Chassis. And then slide the Drive Lever to the state of Fig.1
*1: If A-part (Fig.3) is not moved sufficiently, the Drive Lever cannot be engaged suitably.
In this case, the Idle Gear may be on the position of red dashed line (Fig.5),
so move A-part (Fig.3) to the direction of arrow while moving the Idle Gear
to the direction of arrow (Fig.5)
Judge sufficient movement of A-part based on the position of C-part of Fig.5.
Biasing Spring of Drive Lever
Fig.1
Fig.2
Fig.4
Fig.3
Fig.5
C-part: NG position
Position of insufficient
movement
C-part: OK position
Position of sufficient
movement
Idle Gear
B
C
D
A
