28
CX-3311
1
2
3
4
A
B
C
D
E
F
1
2
3
4
3.9 HOW TO REMOVE AND INSTALL THE CLAMP ARM ASSY
1. According to “3.6 HOW TO REMOVE THE CRG MECHANISM ASSY”, remove the CRG Mechanism ASSY.
(Mechanism – Eject status)
2. According to “3.3 HOW TO CREATE EMPTY CLAMP STATUS (CRG MECHANISM)(MANUAL)”, create empty clamp
status.
3. Remove the Right Biasing Spring of Clamp Arm. (Only the spring of Clamp Arm side. Do not remove that of Chassis side.)
4. Hold the Clamp Arm ASSY up to the state of Fig.2 (open lock status).
5. Furthermore, hold the Clamp Arm ASSY up to the state of Fig.3 while lightly pushing A-part.
6. Remove the Left Biasing Spring of Clamp Arm.
7. Furthermore, hold the Clamp Arm ASSY up to 45 ~ 60 °, and slide to the left then remove it (Fig.1).
How to install:
1. Slide the Clamp Arm ASSY from the left and install to the support with it tipped (45 ~ 60 °).
2. Tip the Clamp Arm ASSY to the position of Fig.3 (position where it stops by contacting with the Chassis.)
3. Install the Left Biasing Spring of Clamp Arm.
4. Turn the Detection Arm completely to the position of OK in Fig.4, and tuck the Clamp Arm ASSY.
5. Install the Right Biasing Spring of Clamp Arm.
(Note) When the Clamp Arm ASSY is replaced, replace the Polyester Film with a new one.
Fig.2
Fig.3
Left Biasing Spring
Fig.4
OK
NG
Fig.1
Right Biasing Spring
Polyester Film
A
