26
CX-3311
1
2
3
4
A
B
C
D
E
F
1
2
3
4
3.6 HOW TO REMOVE THE CRG MECHANISM ASSY
1. Remove the four Fixing Screws of Upper Chassis and remove the Upper Chassis. (Fig.1 and Fig.2)
(The same applies to the mechanism of different type of the Upper Case)
2. Remove it from the three Dampers while moving the Carriage Mechanism part up (Fig.2).
(Note) When the CRG Mechanism ASSY is installed, apply the ethanol to the Dampers.
Check that the tip of Centering Front Spring is located within inside the bend (Fig.3).
Check that the Damper Shaft is located within the Centering Spring (Fig. 4).
When assembling the CRG Mechanism, create an empty clamp state according to “3.2 HOW TO CREATE EMPTY
CLAMP STATUS (MECHANISM MODULE)(MOTOR-DRIVEN)" and press down the upper part of Damper of the
CRG Mechanism so that the Damper and the CRG Mechanism ASSY are firmly in engagement with each other
(Fig. 5).
Fixing Screw of Upper Chassis
Fig.1
Fig.4
NG:
Shaft is outside the
spring.
Fig.2
Damper
Fig.3
Fig.5
OK:
Shaft is inside the
spring.
Tip of the spring should
be within the red circle.
OK: Upper part of Damper is flat.
NG: Damper dents.
