23
CX-3311
5
6
7
8
5
6
7
8
A
B
C
D
E
F
3.3 HOW TO CREATE EMPTY CLAMP STATUS (CRG MECHANISM)(MANUAL)
1. According to “3.6 HOW TO REMOVE THE CRG MECHANISM ASSY”, remove the CRG Mechanism ASSY. (mechanism
– Eject status)
2. Remove the Joint Washer of Drive Gear, and remove the Drive Gear (Fig.1).
(Note) Do not reuse the Joint Washer.
3. Move the Clamp Arm ASSY up to the status of Fig.2-b (Open lock status).
4. Put a finger on A part of Fig.2-c and slide it in the direction of arrow (Direction of play state).
5. Push the Clamp Arm down.
(Note) When the CRG Mechanism is returned to eject status, install the Drive Gear after it is put to eject status by sliding
the Drive Lever to prevent tooth break of the pinion of Drive Gear in the installation.
Joint Washer
Drive Gear
Fig.1
Fig. 2
a. Eject status
/ with a gap
b. Open lock status
/ without a gap
c. Empty clamp status
with a gap
without a gap
A
